Uline H-3630 Manual De Instrucciones página 3

HARDWARE INCLUDED
• (2) M6 x 12 mm Phillips Head Bolts
• (2) M6 Hex Nuts
• (2) M6 Flat Washers
NOTE: Install add-on shelf only after starter
table, add-on table and starter table shelf
have been fully assembled and all bolts and
nuts are tightened.
Figure 8
Cross Bar
PAGE 3 OF 9
ADD-ON SHELF ASSEMBLY
1.
2. Fasten add-on shelf to starter table shelf with two
1-800-295-5510
uline.com
Position add-on shelf underneath add-on table.
Align flat end of add-on shelf with holes over holes
located on starter table shelf. The add-on shelf will
overlap the starter shelf. Place other end of add-on
shelf over add-on table cross bar. (See Figure 8)
M6 x 12 mm Phillips head bolts, M6 hex nuts and
M6 flat washers using a 10 mm wrench and Phillips
screwdriver. (See Figure 8)
1021 IH-3630