Home Decorators Collection 52-FORY Guía De Uso Y Mantenimiento página 10

Assembly - Attaching the Light Kit (continued)
8
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit.
NOTE: Notice the location of the fan's slide switch. This is the
switch used to change the fan's directional rotation. For more
information on the operation of this switch, see Operatiing
your fan on page 11.
□
Remove one screw (PP) from the light kit pan (F) and loosen
but do not remove the other two screws.
□
Connect the wires from the light kit fitter assembly (G) to
the wires from the light kit fan (F) by connecting the molded
adaptor plugs together. Carefully tuck all wires and splices
into the switch cup.
□
Push the light kit fitter assembly (G) up to the light kit fan
(F) so that the two loosened screw heads fit into the keyhole
slots. Turn the light kit fitter assembly (G) clockwise.
□
Re-install the screw (PP) that was removed in step 1.
□
Make sure all the screws are firmly tightened.
PP
9
Installing the shatter resistant bowl
□
Place the shatter resistant bowl (H) into the light kit pan (F),
aligning the three flat areas on the top flange of the shatter
resistant bowl (H) with the raised dimples in the light kit pan.
□
Turn the shatter resistant bowl (H) clockwise until it stops.
□
Attach the pull chain extensions (DD) to the fan pull chains and
light pull chains.
9
F
G
10
WARNING: Allow the shatter resistant bowl to cool
completely before removing.
CAUTION: Make sure the power is off before attaching or
removing the shatter resistant bowl.
F
H
DD