Assembly
Please refer to the illustrations at the back of
the user instructions.
Step 1
Check that all the parts are included – see
manual.
Step 2
Take the 2 braces (7) and attach them to the
container (1).
Step 3
Then attach the support leg (5) and secure it
using 4 nuts (11) and 4 bolts (10).
Step 4
Attach the handlebar (4) to the braces (7)
using 2 bolts (12) and nuts (11).
Step 5
Attach the handle to the handlebar section
using 2 bolts (12) and 2 nuts (11).
Step 6
Attach the wire securely under the base of
the container and secure it using the 2 small
screws provided.
Step 7
The gear housing (2) is placed under the
container (1).
Step 8
The wheels (8) are � tted to the crossbar (6)
on both sides of the braces (7) using a split
pin (14) and a washer (13) on each side. Then
attach the supplied hubcaps (9).
Step 9
Insert the B split pin (15) into the bottom of
the container.
Step 10
Check the cable and loosen or tighten it if
necessary. Attach the rubber valve (16) to
the bolts (10+12).
Service centre
Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
•
Complaints
•
Replacement parts
•
Returns
•
Guarantee issues
•
www.schou.com
Manufactured in P.R.C.
Manufacturer:
Schou Company A/S
Nordager 31
DK-6000 Kolding
All rights reserved. The content of this manual may not
be reproduced, either in full or in part, in any way by
electronic or mechanical means, e.g. photocopying or
publication, translated or saved in an information storage
and retrieval system without written permission from
Schou Company A/S.
GB
11