Tools Required; Part Description - Whittier Wood Products 96W Instrucciones Para Armar

96W Country Arrowback Chair
Phillips Head Screwdriver, Rubber Mallet, Hammer, Nail Set, Drill, 3/32" Drill Bit, and Glue.
BEFORE BEGINNING ASSEMBLY, check that the quantities of the parts received
PART DESCRIPTION
A Seat . . . . . . . . . . . . . . . . . . . . . . . 1
BB Back . . . . . . . . . . . . . . . . . . . . . . . 1
C Back Post. . . . . . . . . . . . . . . . . . . 2
DD Back Spindle . . . . . . . . . . . . . . . . 4
E Front Leg . . . . . . . . . . . . . . . . . . 2
F Back Leg . . . . . . . . . . . . . . . . . . . 2
G Side Stretcher . . . . . . . . . . . . . . . 2
H Front Center Stretcher . . . . . . . . . 1
ASSEMBLY INSTRUCTIONS
IMPORTANT:
READ GLUING HINTS
BEFORE ASSEMBLING!
Not intended for use by children
without adult supervision.
FIG. 1
1) Spread glue evenly into the four center holes in the top of the seat (A). Insert chucked ends of the
four back spindles (DD) into these holes, as shown in FIGURE 1.
2) Spread glue evenly in the 2" oblong holes in the back posts (C). Put the back (BB) and back posts
(C) together as shown in FIGURE 1. Spread glue thinly but evenly in the four holes in the bottom of
the back (BB), (too much glue and it will drip out) and in the two outside holes in the seat. Insert the
back posts (C) into these holes while working the back spindles (DD) into holes in the back, one at
a time. Turn the back spindles (DD) so that the fl at portions follow the curve of the back (BB). It may
be necessary to use a rubber mallet or hammer that has been padded to pound these pieces into
place. It is important that the shoulders of the back posts and spindles are in contact with the seat.
NOTE: The back posts (C) extend below the bottom of the seat when inserted; therefore, it is neces-
sary to extend the back over the edge of your work table or place something under the seat to raise
it up.
Page 2 — 96W

TOOLS REQUIRED:

match those on the parts list below.
QTY PART
BB
C
DD
DESCRIPTION
I Back Center Stretcher . . . . . . . . .1
J #8 x 1¾" Pan Head Screws. . . . . .2
K 1" Brad . . . . . . . . . . . . . . . . . . . . .4
L Wedges . . . . . . . . . . . . . . . . . . . .2
M Wood Buttons. . . . . . . . . . . . . . . .2
N #8 x 1 / "Black Screw . . . . . . . . . .4
5
8
O #8 x 1¼" Black Screw . . . . . . . . . .4
C
A
QTY
Shoulder
Chuck