Whittier Wood Products 232W Instrucciones De Montaje página 4

F
x 12
G
x 8
FIG. 3A
Front
3. Install three Drawer Slides (Cabinet Side Left) (E2) using Screw (F) into the small predrilled holes
in the left set of Slide Supports (A & B). Use the first hole behind the slide wheel and the last hole
on the slide. Make sure the slide wheels face out as shown in FIGURE 3A.
Repeat and install three Drawer Slides (Cabinet Side Right) (E1) onto the right set of Slide
Supports (B & A). Make sure the slide wheels face out as shown in FIGURE 3B.
4. Tap in the Wood Dowels (G) into the larger holes on each Slide Support (A & B) as shown in
FIGURE 3A & 3B. Start from the side that has the drawer slides and tap the dowel out the other
side until 1/4" of the dowel is showing. Do not glue dowels.
H
x 8
FIG. 5A
5. The left slide support assembly needs to be installed on the left side of the shelf compartment.
The right slide support assembly needs to be installed on the right side of the shelf compartment.
To do so, align the four wood dowels that extend from the opposite side from the slides into the
column of holes in the base unit normally used for the adjustable shelves. This should be the top
most and bottom most holes in each column of holes. Once the slide support assembly is flush
with the side of the base unit, secure each assembly using Screw (H) in the holes as show in
FIGURE 5A & 5B.
Proceed to Step 14 to complete assembly.
Page 4 — 232W/243W
G
G
E2
F
F
E2
F
G
F
G
Rear
E2
F
F
H
H
H
H
G
G
E1
F
F
E1
F
G
F
G
Rear
E1
F
F
H
H
H
H
DO NOT
GLUE
DOWELS
FIG. 3B
Front
DO NOT
GLUE
DOWELS
FIG. 5B