Whittier Wood Products 232W Instrucciones De Montaje página 5

243W DRAWER
FIG. 6
Small holes on LEFT edge
6. Arrange Thick Front Slide
Support (A), Thick Rear Slide
Support (B), Thin Rear Slide
Support (C) and Thin Front
Slide Support (D) as shown
in FIGURE 6.
Make sure the holes are oriented as shown in the diagram.
F
x 12
G
x 8
FIG. 7A
Front
7. Install three Drawer Slides (Cabinet Side Left) (E2) using Screw (F) into the small predrilled
holes in the Thick Set of Slide Supports (A & B). Use the first hole behind the slide wheel and
the last hole on the slide. Make sure the slide wheels face out as shown in FIGURE 7A.
Repeat and install three Drawer Slides (Cabinet Side Right) (E1) onto the Thin Set of Slide
Supports (C & D). Make sure the slide wheels face out as shown in FIGURE 7B.
8. Tap in the Wood Dowels (G) into the larger holes on each Slide Support (A, B, C & D) as shown
in FIGURE 7A & B. Start from the side that has the drawer slides and tap the dowel out the
other side until 1/4" of the dowel is showing. Do not glue dowels.
INSTALLATION IN A
LEFT SHELF COMPARTMENT
Large holes down center
Front
Small holes on LEFT edge
G
E2
F
Thick
Set
E2
G
F
G
E2
F
Large holes on edge
Thick
Set
Rear
G
G
E1
F
F
E1
F F
G
Rear Rear
E1
F F
235W BASE
Large holes down center
Thin
Set
Front
Rear
Small holes on RIGHT edge
G
F
Thin
Set
F
G FIG. 7B
Front
F
Small holes on
RIGHT edge
DO NOT
GLUE
DOWELS
232W/243W — Page 5