Whittier Wood Products 232W Instrucciones De Montaje página 6

H
x 8
Left Side
Panel
FIG. 9A
9. The left slide support assembly (A & B) needs to be installed on the left side of the left shelf
compartment. See FIGURE 9A. The right slide support assembly (C & D) needs to be installed
on the vertical divider. See FIGURE 9B.
To do so, align the four wood dowels that extend from the opposite side from the slides into the
column of holes in the base unit normally used for the adjustable shelves. This should be the top
most and bottom most holes in each column of holes. Once the slide support assembly is flush
with the side of the base unit, secure assembly using Screw (H) in the holes as show in FIGURE
9A & 9B.
Proceed to Step 14 to complete assembly.
243W DRAWER
FIG. 10
Small holes on LEFT edge
10. Arrange Thin Front Slide
Support (D), Thin Rear Slide
Support (C), Thick Rear
Slide Support (B) and Thick
Front Slide Support (A) as
shown in FIGURE 10.
Make sure the holes are oriented as shown in the diagram.
Page 6 — 232W/243W
H
H
H
H
INSTALLATION IN A
RIGHT SHELF COMPARTMENT
Large holes down center
Front
Small holes on LEFT edge
Large holes on edge
Thin
Set
Rear
H
H
H
H
235W BASE
Large holes down center
Thick
Set
Rear
Small holes on RIGHT edge
DO NOT
GLUE
DOWELS
Vertical
Divider
FIG. 9B
Small holes on
RIGHT edge
Front