Whittier Wood Products 232W Instrucciones De Montaje página 8

N
x 8
N
N
N
N
FIG. 14A
14. Attach two Drawer Sides (I) to one of the Drawer False Fronts (J) with Screw (N) through the
pre-drilled holes in the sides. The grooves for the Drawer Bottom must line up. Slide the Drawer
Bottom (K) into the grooves. Attach the Drawer End (L) to the sides in the same manner. Repeat
for the other two Drawers. See FIGURE 14A.
Square the drawers by measuring from left front to right rear and from right front to left rear. The
measurements should be equal. If one is longer, hold the drawer by the corners on the longest
line and squeeze them together until square. See FIGURE 14B.
F
x 6
x3 drawers
FIG. 15
15. Attach Drawer Slides (Drawer Side Left) (E4) and (Drawer Side Right) (E3) to the drawers. The
wheels should be to the rear and the front edge should be flush with the drawer sides. Attach the
slides with three Screws (F). See FIGURE 15.
Page 8 — 232W/243W
DRAWER ASSEMBLY
x3 drawers
F
F
N
N
N
N
E3
F
232W Standard 3-Drawer Kit
shown in the following drawings.
FIG. 14B
E4
F
F
F