Zoeller STBB200 Manual De Instrucciones página 17

START-UP AND OPERATION
1. WARNING: Disconnect the primary pump from
the 115V outlet before touching any component
in the sump basin.
Test the installation for leaks by running water
into the sump basin. The primary pump should
operate normally.
2. Check the controller. The system light should
be green when the unit is plugged into a 115V
outlet.
3. NOTE: When the unit is first plugged in, all
lights will flash and an alarm will sound to verify
proper operation. The charger may not begin
charging for several minutes. When the battery
begins charging, the four lights in the circle will
turn blue, with the battery light flashing blue.
1
2
All lights
will be
green when
plugged
into 115V
outlet
3
Flashing blue light
when charging
17
© 2020. All rights reserved.
GFCI Outlet
by
AC FLOAT
POWER STATUS
TEST
24/7 BASEMENT
PROTECTION
BATTERY DC
PUMP
SILENCE
USB
DC POWER
1-800-584-8089 DC FUSE + 15V DC 1.6A
BasementSentry.com RESET FLOAT PUMP 30 AMP
P L U S
AC FLOAT
POWER STATUS
24/7 BASEMENT
PROTECTION
DC
BATTERY
PUMP
USB
1-800-584-8089
DC FUSE
BasementSentry.com
RESET FLOAT PUMP 30 AMP
by
P L U S
AC FLOAT
POWER STATUS
24/7 BASEMENT
PROTECTION
DC
BATTERY
PUMP
USB
1-800-584-8089
DC FUSE + 15V DC 1.6A
BasementSentry.com
RESET FLOAT PUMP 30 AMP
by
TEST
SILENCE
DC POWER
+ 15V DC 1.6A
Solid blue light
when charging
TEST
SILENCE
DC POWER