MAURER 96999 Manual De Instrucciones página 7

Cod. 96999
Mount the crevice nozzle by inserting the rear part into the suction opening of the device
until it is properly locked in place.
Brushhead
With brushhead you can dust off books or clean delicate object like painting frames,
lampshades, keyboards, etc.
Mount the brushhead by inserting the rear part into the suction opening of the device until it
is properly locked in place.
Special Safety Instructions
If the air inlet of the cordless vacuum cleaner or the detachable accessories are clogged,
switch the vacuum cleaner off immediately. Before you switch the vacuum cleaner again,
remove the clogged objects.
1. Do not use the vacuum cleaner in the immediate proximity to sources of heat and do not
suck up hot objects, e.g. cigarette butts or ashes.
2. Always connect the power plug with the socket with dry hands.
3. Before you start using the vacuum cleaner, first remove big or sharp object from the
floor in order to avoid possible damages.
4. When disconnecting the power plug, do not pull the cord.
Caution!
Do not let children play with the packaging material – there is danger of suffocation.
Operation
Before mounting or dismounting the device or the accessories, always disconnect the power
plug of the net adaptor from the socket first!
Mounting on the wall
The cordless vacuum cleaner is supplied with a wall holder. Select a suitable place for the
holder. It should be located in a dry place, close to a socket.
Caution!
Before mounting or dismounting the device or the accessories, always disconnect the power
plug of the net adaptor from the socket first!
1. Place the wall holder as well as fastening devices on the floor or a table and check them
for possible damages.
2. Hold the wall holder on the selected place and mark the drilling holes with a pencil.
3. Mount the wall holder with the corresponding screws and wall plugs.
4. If the jack plug has not already been attached to the wall holder, place it in the
corresponding holder.
Charging the battery
Caution!
Before mounting, make sure that you will not damage any pipelines. Find out exactly where
the pipelines are.
You can choose if you want to charge the device on the wall holder, or if you want to charge
the device directly with the net adaptor (without the wall holder).
1. If you want to use the wall holder, place the device in the holder, with the collection
container facing up.
2. If you do not use the wall holder, place the jack plug of the net adaptor into the
connection socket on the backside of the vacuum cleaner.
3. Then connect the net adaptor with a 230V-50Hz socket.
4. The red control lamp signals the correct connection of the power plug with the vacuum
cleaner and also that the vacuum cleaner is being charged. After about 12 hours the
battery of the vacuum cleaner is fully charged.
7