SATA AE1032H Manual De Instrucciones página 50

- Check that the pressure and flow-rate pro¬vided by the
compressed air system are compatible with those required
for proper operation of the machine - see "Technical Data"
section. For correct machine opera¬tion the compressed
air supply line must provide a pressure range from no less
than 8 bar to no more than 16 bar.
- Connect the compressed air system by means of a supply
pipe connected to the intake of the air treatment unit on
the REAR SIDE of the machine base.
- Check that there is air lubrication oil in the Lubricating
unit; refill if there is little or no oil. Use SAE20 oil.
- The customer must provide an air cut-off valve upstream
of the air treatment and re¬gulating device supplied with
the machine.
WARNING
Connection 1 should be considered as an emergency valve to disconnect the machi¬ne from the air line (fig.6)
The equipment is intended for professional use only.
WARNING
Only one operator may work on the equipment at a time.
WARNING
Failure to comply with the instructions and danger warnings may seriously injure ope¬rators and any other
person present near the machine. Do not operate the machine until you have read and understood all the
danger, warning and caution notices in this manual.
This machine must be used only by quali¬fied and authorised personnel. A qualified operator is construed as a
person who has read and understood the manufacturer's instructions, is suitably trained, and is con¬versant with
safety and adjustment proce¬dures to be adhered to during operations. Operators must not use the machine
under the influence of alcohol or drugs which may affect their capacity.
The operator must, in all cases:
- Be able to read and understand all the information in this manual.
- Have a thorough knowledge of the capa¬bilities of this machine.
- Keep unauthorised persons well clear of the area of operation.
- Make sure the machine has been installed in compliance with all relevant regulations and legislation.
- Make sure that all machine operators are suitably trained, that they are capable of using the equipment
correctly and that they are adequately supervised.
- Never leave nuts, bolts, tools or any other equipment on the tyre changer as they may become entrapped
between moving parts.
- Not touch power lines or the inside of electric motors or any other electrical equipment before making sure the
power supply has been disconnected.
- Read this manual carefully and learn how to use the machine correctly and safely.
- Always keep this user and maintenance manual in an easily accessible place and consult it whenever necessary.
AE1032H
50
- 03 -
EN DE RU KO PT
( Fig. 6 )
JA ES