Glacier bay 67276-8004 Guía De Uso Y Mantenimiento página 6

Installation (continued)
3
Connecting the hose
□
Align the tabs (1 & 2) on the quick connect
assembly (J).
□
Push the quick connect assembly (J) rmly
upward and snap it onto the receiving tube tab.
Pull down moderately to ensure the connection
has been made.
□
If it is necessary to remove the quick connect
assembly (J), squeeze the tabs on the hose,
and then pull down to disconnect.
1
2 J
4
Making the waterline
connections
NOTE: The hot side inlet tube is indicated by a label.
If the label is not present, the hot supply tube is the longer
of the two inlet tubes.
□
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
1
3
NOTE: Before tightening the faucet connector to the water
supply, apply a second wrench to the supply tube tting.
This will prevent the supply tube from moving or twisting
when tightening the faucet connector. Do not overtighten.
6
2