Emergency Operation For Wireless Remote-Controller; Care And Cleaning - Mitsubishi Electric CITY MULTI PKFY Serie Manual De Instrucciones

9. Emergency Operation for Wireless Remote-controller

(For PKFY-P·NHMU-E2)
10. Care and Cleaning
˚F
TEMP.
Indicates that the filter needs cleaning.
Ask authorized people to clean the filter.
When resetting "FILTER" display
When the [FILTER] button is pressed two times successively after clean-
ing the filter, the display goes off and is reset.
Note:
When 2 or more different types of indoor unit are controlled, the
cleaning period differs with the type of filter. When the master unit
cleaning period arrives, "FILTER" is displayed. When the filter
display goes off, the cumulative time is reset.
"FILTER" indicates the cleaning period when the air conditioner
was used under general indoor air conditions by criteria time. Since
the degree of dirtiness depends on the environmental conditions,
clean the filter accordingly.
The filter cleaning period cumulative time differs with the model.
This indication is not available for wireless remote controller.
Cleaning the filters
• Clean the filters using a vacuum cleaner. If you do not have a vacuum
cleaner, tap the filters against a solid object to knock off dirt and dust.
• If the filters are especially dirty, wash them in lukewarm water. Take care
to rinse off any detergent thoroughly and allow the filters to dry completely
before putting them back into the unit.
Caution:
• Do not dry the filters in direct sunlight or by using a heat source,
such as an electric heater: this may warp them.
• Do not wash the filters in hot water (above 50°C, 122°F), as this may
warp them.
• Make sure that the air filters are always installed. Operating the unit
without air filters can cause malfunction.
• Before you start cleaning, stop operation and turn OFF the power
supply.
• Indoor units are equipped with filters to remove the dust of sucked-
in air. Clean the filters using the methods shown in the following
sketches.
16
D C
B
A
E
˚F
FILTER
ON/OFF
When the remote-controller cannot be used
When the batteries of the remote controller run out or the remote control-
ler malfunctions, the emergency operation can be done using the emer-
gency buttons.
A DEFROST/STAND BY lamp
B Operation lamp
C Emergency operation switch (heating)
D Emergency operation switch (cooling)
E Receiver
Starting operation
• To operate the cooling mode, press the
seconds.
• To operate the heating mode, press the
seconds.
Note:
• Details of emergency mode are as shown below.
Details of EMERGENCY MODE are as shown below.
Operation mode
Set temperature 24°C, 75°F
Fan speed
Airflow direction Horizontal
Stopping operation
• To stop operation, press the
than 2 seconds.
Filter removal
Caution:
• In removing the filter, precautions must be taken to protect your
eyes from dust. Also, if you have to climb up on a stool to do the
job, be careful not to fall.
• When the filter is removed, do not touch the metallic parts inside
the indoor unit, otherwise injury may result.
PKFY-P·NBMU-E2
PKFY-P·NHMU-E2
1 Pull both the bottom corners of the intake grille to open the grille, then
lift the filter.
button D for more than 2
button C for more than 2
COOL HEAT
24°C, 75°F
High High
Downward 4 (5)
button D or the button C for more