Fiap TrommelSieve Active Manual De Instrucciones página 14

FIAP TrommelSieve Active
Care and maintenance
Please note, in addition to complement this manual, our FIAP TrommelSieve Active
demonstration videos under http://www.youtube.com/user/FIAPGmbH
Purge rinse system
Control spray nozzles all 2 weeks and when required clean spray nozzles
Exchange spray nozzles after 2 years
Dismantling and cleaning of the nozzles:
1. Switch off the main switch and put down the dishwater supply.
2. Remove the bayonet socket, while you turn this around ¼ against the clockwise.
Pay attention to the fact that the elastic seal (nozzle seal) does not get lost.
3. Clean the nozzle with air pressure or with a plastic brush.
Never use a steel brush or a cleansing needle because these can destroy the nozzle.
4. The assembly of the nozzle occurs in reverse order.
You should control that the bayonet socket is correctly tightened up to the stop.
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
27
www.fiap.com
FIAP TrommelSieve Active
Bearing
The opposite bearing of the filter drum is a sliding bearing from POM and maintenance-free.
Slide
bearing
Drive system: Protective cover
Before you begin with servicing work, the current is to be switched off to the filter.
Remove the security disguising around the drive system.
Pay attention to the fact that the security disguising is correctly mounted before the next start of the
filter again.
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
Protective cover
28
www.fiap.com