LEXIBOOK TV Game Console Manual De Instrucciones página 10

Ocultar thumbs Ver también para TV Game Console:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
the game is powered by an adapter, do not play outside. Check the state of the adapter and the connection cords
regularly. If their condition is deteriorating, do not use the adapter until it has been repaired. The game may only be
operated with the recommended adapter. The adapter is not a toy. The console should be disconnected from the
power supply to be cleaned if liquids are used for cleaning.
Wireless controllers:
1. Use a screwdriver to open the battery compartment located at the back of the controller.
2. Install the 3 x LR03/AAA type batteries observing carefully the polarity indicated at the bottom of the battery com-
partment and as per the diagram shown below.
3. Close the battery compartment and tighten the screw.
4. Repeat the 3 previous steps to install the batteries of the second controller.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the toy
before being charged. Rechargeable batteries are only to be charged under adult supervision. Different types
of batteries or new and used batteries are not to be mixed. Only batteries of the same or equivalent type as
recommended are to be used. Batteries are to be inserted with the correct polarity. Exhausted batteries are to
be removed from the toy. The supply terminals are not to be short circuited. Do not throw batteries into a fire.
Remove the batteries if you are not going to use the game for a long period of time.
WARNING: Mal-function or loss of memory may be caused by strong frequency interference or electrostatic dis-
charge. Should any abnormal function occur, reset the unit or remove the batteries and insert them again, or unplug
the AC/DC adapter from the mains socket and plug it back in.
Connecting the console to a TV set
The "TV Game Console" must be plugged to a TV set.
Note: The TV set and the console MUST BE TURNED OFF.
1. Plug the AV cable (yellow end) into the matching video input jack on the TV set.
2. Plug the AV cable (white end) into the matching audio input jack on the TV set.
3. Switch on the TV set and turn on the console.
Positioning the console in the play area:
- Place the console observing carefully the diagram shown
opposite.
- Ensure you have enough space and there are no ob-
stacles in the play area (furniture, overhead light, carpet...)
- Place the console on a flat and steady table at about the
same height as the television.
- Play directly in front of the television within a distance of 1
meter from the console.
Note: Do not use other controllers in the same room and
during the game, it may occur abnormal function of the
console.
10

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Jg7400

Tabla de contenido