Power Supply; Preparing The Adapter Box; Preparing The Receiver; Preparing Evolution 4000 For Video Transmission - MSA EVOLUTION 4000 Manual Del Usuario

GB

3.1.3 Power supply

The adapter box must be connected to a electrical supply. The
provided power supply is used for the 230 V connection. The
provided vehicle connection cable is used for a motor vehicle
(turn and remove red protective cap).
Different adapters are available for the power stage.

3.1.4 Preparing the adapter box

The supply cable is plugged into the corresponding socket
on the rear of the adapter box. The control light on the front
indicates the electrical supply present.
The cable from the receiver unit, on the rear of the antenna, is
plugged into the DIN AV socket on the rear of the adapter box.
The connection must now be made between the adapter box
and an NTSC-Monitor (not included in the scope of supply) with
the BNC-cable.
Switch on the monitor in accordance with the operating
instructions.
GB

3.1.5 Preparing the receiver.

The receiver unit is located on the rear of the antenna.
2 channels can be selected on the receiver.
3.2 Preparing EVOLUTION 4000
for video transmission
Switch on the camera in accordance with the operating instruc-
tions. Switch on video transmission. The channel selected on
the camera must correspond to the receiver unit channel.
The selected channel is indicated on the camera LCD display
on the right top.
11