Brandson 305385 Manual Del Usuario página 36

1. Open the battery compartment of the outdoor sensor
2. Replace all the batteries in the sensor with new ones.
3. Press the button "for manual signal" on the weather station.
4. Press the "RESET" button on the 5-IN-1 sensor outdoor sensor.
5. The outdoor sensor and the weather station should be connected
within the next few minutes. If this does not happen, repeat this
process.
7. Basic settings
1. Press and hold the "SETTINGS" button in normal mode for about 3
seconds to access the settings.
2. Adjust the value using the "UP / TEMP" or "DOWN / WIND" buttons
The adjusted value is confirmed by pressing the "SETTINGS" button.
3. The setting cycle is as follows:
• BEEP ON/OFF
• Unit of temperature: °C /°F
• Air pressure unit: hPa / inHg / mmHg
• Wind speed unit: km/h / mph
• Selection of wind degree (angle) or direction (letter)
• Unit of rainfall: mm / inch
• Wireless clock function: ON / OFF
• Time zone: -1 to 2 hours
• Hour format: 24 hours / 12 hours
• Hour
• Minute
• Calendar display format: Month / Date / Date / Month
• Year
• Month
• Day
• Language setting - To set the language for the day on the
display. The following codes can be configured and selected:
ENG (English), GER (German), FRE (French), SPA (Spanish), ITA
(Italian), DUT (Dutch), DAN (Danish)
• Initialising the weather settings
36
.
English