Troubleshooting - Edesa VE-031 S Manual De Uso

1/2
Half Load
If you wish, you can wash only half the full dishwasher load (=6 place services). To do
this: 1) Choose the programme, as shown in the corresponding boxes; 2) press the 1/2
button, and 3) place the dishes in the upper basket. The amount of detergent you should
add is 15 + 5 grs. for the Intensive Programme and 15 grs. for all other programmes.
NOTE:
In type A models, while washing is in progress, pilot lights
optional function buttons selected
which correspond to the optional funcion buttons
If a failure occurs in your dishwasher, you will hear a continuous warning beep and the
problem type will light up on the display at the same time (F1,F2,F3...F8).
Here is a troubleshooting table: The problems detailed in the table will depend on the model
of dishwasher.
If you have any of the problems shown in this table, first check that the dishes are placed
correctly and restart the programme as described in section 2 above (Programme selection)
MODEL
PROBLEM
Door open
Water not entering
Doesn't drain
Overflows
Overheats
Does not heat up
Temperature Sensor
Lack of water pressure
-Intermittent
-Off
NOTE: If in type A models, you see that any of the phase pilot lights
or in type B models, that pilot light
,and it will emit the same number of beeps as the number of the problem. Beep
13
detection can be repeated as often as you wish.
IMPORTANT:
If the problem persists, make a note of it (as shown in the Table) and contact the
ASSISTANCE SERVICE
This table is also shown on the upper door rim
dishwasher door).
11 , light up, and in type B models the pilot light

TROUBLESHOOTING

PHASE PILOT LIGHT (type A)
F1
F2
F3
F4
F5
F6
F7
F8
or
14
15
, which correspond to the
12
, light up.
16
DISPLAY
is flashing, press the Start/Pause button
(it can be seen by partly opening the
28
17
PHASE PILOT LIGHT (type A y B)
1
2
3
4
5
6
7
8
are flashing
10
TECHNICAL
,
40