Inserting The Batteries - IEM Tel-O-Graph GSM plus Manual De Instrucciones

Inserting the batteries

Fig. 4: Opening the battery cover
Note
▪ Insert the batteries while holding the blood pressure monitor in your hand.
Take care not to activate the button on the front!
▪
▪ By pressing the button when inserting the batteries, you will enter the pressure gauge mode used for
servicing purposes. Remove the batteries and insert the batteries again.
WARNING
Make sure that all segments are displayed by the screen. Inform your healthcare provider/physician if the
display is damaged.
Preparing the measurement
1. Open the battery cover on the underside of
the blood pressure monitor.
2. Insert four batteries (AA, alkaline), with the
poles aligned correctly.
3. Close the battery cover.
 The blood pressure monitor switches on
automatically, carries out a display test and
displays the start screen. (see Fig. 6).
DE
EN
23