Installation Instructions; Troubleshooting - Concept CA1030 Manual De Instrucciones

EN

INSTALLATION INSTRUCTIONS

• In case of internal dust, such as pollen, the appliance should be placed on the ground. Since pollen, dust, etc. are
usually held close to the floor, it is recommended to place the purifier on a flat floor in the room.
• In order not to block the air inlet and outlet, place the appliance about 30 cm or more away from the left and right
sides of the wall, furniture, curtains, etc. For effective use of the appliance, please keep it at least 20 cm away from
the wall behind it.
• Do not place any objects on the top of the appliance (this may cause the appliance to malfunction).
• Note: Do not place magnets or metal objects on the appliance.
• Do not block the air inlet and outlet, for example, do not place any objects on the air outlet. Or on the front side,
on the air inlet.
MANDATORY MAINTENANCE
• Switch off the appliance immediately if any of the following situations occur (could cause electric shock, spark or
smoke)
- Unusual sound or vibration occurs during operation
- The appliance is unusually hot and there is a smell of burning
• Clean the plug regularly
- If the plug is dusty, moisture may damage the insulated part of the plug and cause a fire.
- If the appliance is not used for a long time, unplug the power cord.
• Be sure to disconnect the power supply before performing any maintenance on the appliance. The appliance may
suddenly start and cause electric shock and injury.
• Connect the plug to the wall socket correctly (if the plug is not inserted correctly, it may result in electric shock due
to overheating or even a fire). Do not use a damaged plug or loose socket.
• Always pull the power cord by the plug. Pulling on the cord may cause damage to the power cord, electric shock,
short circuit, or fire.
• If any of the following occurs, immediately turn off the power to the appliance and contact an authorized service
centre.
- The power button does not work.
- The power cord or plug is unusually hot.
- You noticed unusual sound or vibration.
- There are any other abnormalities or faults.
• To prevent electric shock, unqualified persons should not disassemble the appliance.
58

TROUBLESHOOTING

Common faults, error code description and troubleshooting method.
Problem
It is not possible to turn on or press
the button, no response
The button does not respond
The odour from the appliance outlet
is unpleasant
The purifier runs for a long time,
but the air quality does not improve
significantly
CA1030 CA1030
Cause
Is the power cord plugged in? Plug in the power cord.
Is the front cover of the appliance Install the front cover of the
installed?
Is the filter dirty? Clean the filter.
Is the filter unchanged for a long
Replace the filter with a new one.
time?
Has the plastic bag been removed Remove the plastic bag from the
from the filter before installation? filter before first use.
Follow the installation instructions
Is the filter installed correctly?
and precautions.
The filter indicator is on: this means At this point, after changing the
that the filter change timer has filter, press and hold the "sleep"
reached the set value. button to reset.
EN
Remedy
appliance.
59