AMG CANADIAN IDRO 17 Manual Del Usuario página 76

Ignition
Remove any components which might burn from the rebox and from the glass
(various instructions and adhesive labels)
Charge pellet
Fuel is loaded from the upper part by opening a door. Pour the pellets in the hopper. When empty, this
is easier if performed in two steps:
• Pour half of the contents of the bag into the hopper and wait for the fuel to settle on the bottom.
• Then pour in the rest.
Never remove the protection grille in the hopper. When lling, do not let the sack
of pellets touch any hot surfaces.
The brazier should be cleaned before each starting.
Control Panel
Button is used to switch the machine on/off and to exit programming.
Buttons and
Buttons and
LED SYMBOL
1
2
3
4
5
6
7
1. Temperature increase
2. Temperature decrease
3. Key SET
4. Pulsante on/off
5. Operating power decrease
6. Operating power increase
For our products use pellets diameter 6 mm, length 30 mm and a maximum of 6%
and A1 certi ed according to the UNI EN ISO 17225-2 standard. Keep the pellets away
from heat sources and not in humid environments or with explosive atmosphere.
28
are used to adjust temperature, for displays and for the programming functions.
are used to adjust heating power.
The LED lights up when a program is active.
The LED lights up when the resistance is active.
The LED lights up when the loading of pellet is active.
The LED lights up when the smoke fan is active.
The LED lights up when the room fan is active. (where present)
The LED lights up when the circulator is active.
The LED lights up when there is a warning.
DESCRIPTION
(Boilers and thermostoves)
21 : 10
22°C P-1
off
21 : 10
22°C P-1
off