Maintenance And Cleaning - AMG CANADIAN IDRO 17 Manual Del Usuario

Maintenance and cleaning

All cleaning of all parts must be carried out with the Thermostove completely cold
and unplugged to avoid burns and thermal shock. The Thermostove does not need
much maintenance if used with certi ed quality pellet. The need for maintenance
varies depending on the conditions of use (switching on and off repeatedly) and
depending on the performance required.
of the Thermostove to check its condition.
Parts
Brazier
Cleaning the ash collection
compartment with suction device
Cleaning ash tray
Door and glass cleaning
Exchanger (turbulators)
Flame beater
Cleaning the interior heat exchanger /
smoke fan compartment
Cleaning complete exchanger
Clean "T" to exhaust
Flue
Door gasket ash
Internal parts
Flue pipe
Circulation pump
Plate heat exchanger
Hydraulic components
Electromechanical components
◊ by the user / • by the authorised quali ed technical assistance
BY THE USER Daily control
The Thermostove requires a simple and thorough
cleaning in order to ensure a more ef cient
performance and smooth operation. Clean the
grate using the appropriate tool from the ash and
any incrustation which could obstruct the passage
of air. In the case of depletion of pellets in the tank
may accumulate unburned pellets in the burn pot.
Always empty the residuals from the grate before
each start. Remember that only a brazier located
and clean properly can ensure ignition and optimal
operation of your Thermostove. When positioning
the crucible, carefully check that the ends of the
pads completely adhere to their home and that
the hole with pipe dedicated to the passage of the
resistance. There should be no residual combustion
in the contact zone between the edges of the
crucible and the support surface on the door
crucible.
38
Every 2-3
Everyday
days
◊
◊
◊
◊
◊
◊
It is recommended periodic monitoring
Every Every 15 Every 30
week days days
Every 60- Every 1
90 days year
•
•
•
•
•
•
•
•
•
•
•