Starting And Stopping - Sandrigarden SG HT/A Serie Manual De Instrucciones

GB

6. STARTING AND STOPPING

WARNING! Do not start theengine
without first fitting the hedge
trimmer correctly (see paragraph 4
Assembly) (see Brush Cutter manual. The
same conditions apply).
STARTING THE ENGINE
1) Position the hedge trimmer in a safe starting
position.
2) Position the cutting blades at an angle (fig. 7)
3) Remove the blade guards. The blades must
not touch the ground or any other object – if
possible, rest the reduction unit on a raised
surface (such as on raised ground, a brick or a
log).
4) Get into a stable position.
5) With the left hand, push hard the equipment
on the ground.
6) Do not rest the foot or the knee onto the shaft.
7) Start the engine as shown in the Brush Cutter
manual (fig. 16).
20
HEDGE TRIMMER OPERATING MANUAL
Fig.16
WARNING – DANGER!! If the engine
starts and stays in the half
acceleration position, the blades are
moving. Let the engine turn for a few
seconds to make sure it warms up. Operate
the trigger once to reduce the engine speed
to idle and stop the blades.
WARNING – DANGER !! If the blades
do not stop when the engine
reaches idle speed, contact a service
centre (see Brush Cutter manual).
STOPPING THE ENGINE
1) To stop the engine, move the switch (fig. 17
item 1) to the "OFF" position.
Fig.17
1
WARNING! The cutting device will
continue to rotate for some time
even after moving the switch to the "OFF"
position. Firmly hold the two handles until
the cutting device comes to a complete stop.
WARNING! Familiarise yourself with
the on/off switch in order to act
promptly in case of emergency.
ON
OFF