Functional Description - Makita BHR200 Manual De Instrucciones

3. Do not allow anything to cover or clog the
charger vents.
4. Do not short the battery cartridge:
(1) Do not touch the terminals with any conduc-
tive material.
(2) Avoid storing battery cartridge in a con-
tainer with other metal objects such as nails,
coins, etc.
(3) Do not expose battery cartridge to water or
rain.
A battery short can cause a large current flow,
overheating, possible burns and even a break-
down.
5. Do not store the tool and Battery Cartridge in
locations where the temperature may reach or
exceed 50°C (122°F).
6. Do not incinerate the Battery Cartridge even if it
is severely damaged or is completely worn out.
The battery cartridge can explode in a fire.
7. Be careful not to drop, shake or strike battery.
8. Do not charge inside a box or container of any
kind. The battery must be placed in a well venti-
lated area during charging.
SAVE THESE INSTRUCTIONS
SYMBOLS
The following show the symbols used for the charger. Be
sure that you understand their meaning before use.
............Ready to charge
...............Charging
...............Charging complete
...........Delay charge (Cooling)
...........Defective battery
...........Conditioning
............Cooling abnormality

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
1
• Always switch off the tool before insertion or
removal of the battery cartridge.
• To remove the battery cartridge, withdraw it from
the tool while sliding the button on the side of the
cartridge.
• To insert the battery cartridge, align the tongue on
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can see
the red part on the upper side of the button, it is not
locked completely. Insert it fully until the red part
cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around
you.
• Do not use force when inserting the battery
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Charging
1
1. Plug the battery charger into the proper AC voltage
source. Two charging lights will flash in green color
repeatedly.
2. Insert the battery cartridge into charger until it stops
adjusting to the guide of charger. Terminal cover of
charger can be opened with inserting and closed
with pulling out the battery cartridge.
3. When the battery cartridge is inserted, the charging
light color will change from green to red and charg-
ing will begin. The charging light will keep lighting
up lit steadily during charging. One red charging
light indicates charged condition in 0 - 80% and two
red ones indicates 80 - 100%.
4. With finish of charge, the charging lights will
change from two red ones to two green ones.
5
003103
1. Battery car-
tridge
2. Red part
3. Button
2
3
001336
1. Terminal cover
2
2. Battery car-
tridge
3. Charging light
3
4. Battery charger
4