Installation Instructions; Step 1 - Assemble Stand - Haier HLP0R02AXW Instrucciones De Instalación

INSTALLATION INSTRUCTIONS

STEP 1 - ASSEMBLE STAND

1. Set the stand upright so that the dryer mounting brackets are at the top.
b
2. Loosen the 6 nuts on the cross brace bolts to allow the braces to slide open.
Cross braces will slide and create pinch points during set-up. Keep
hands clear of sliding cross braces and their connection points.
Do not insert nger into moving parts. Doing so may result in severe
injury, cut or pinch.
3. Grasp the left-hand and right-hand sides of the stand as shown. Pull apart. Make
sure the bolts slide all the way to the end of the slot to ensure the stand is open
completely.
Mounting Brackets
WARNING
Pinch Hazard
5