Changing The Service Password - Storz AUTOCON II 400 Manual De Servicio

4.5.5 Changing the service password

Caution: Make a note of the current password and make sure you don't lose it or forget
– Open the "Service Programs" menu as described in Chapter 4.5.1 Calling the service programs.
– Press the "Change Service Password" button.
– Enter the service password. The service password when the device leaves the manufacturers is
"Tuttlingen".
– Press "Enter"
– Enter the new service password in the input field on the left.
12.06 / V1.0
it. If you should change the password but then forget it, you will no longer be
able to set parameters or make any changes in the service programs. In this
case you should contact the service technician.
to confirm the password.
Figure 4.15
Figure 4.16
AUTOCON ® II 400
MODEL 205352 20-1
4-17