Würth EWS 10-125 COMPACT Traducción Del Manual De Instrucciones De Servicio Original página 28

Quick-clamping nut
(depending on configuration)
Tightening the quick-clamping nut
Attention!
Use the quick-clamping nut [9] only on machines
with "quick-clamping system".
Attention!
If the abrasive wheel [10] is thicker than 6.8 mm
in the clamping area, the quick-clamping nut must
not be used!
¾ Use the two-hole nut [8] with two-hole
wrench [7].
Lock the spindle.
■
Push quick-clamping nut [9] onto the
■
spindle [12] so that the two lugs engage in the
two grooves of the spindle.
Tightening the quick-clamping nut in clockwise
■
direction by hand.
Tighten the quick-clamping nut further by turning
■
the abrasive wheel firmly in clockwise direction.
Loosening the quick-clamping nut
Attention!
Only when the quick-clamping nut [9] is fitted
may the spindle be stopped using the red spindle
locking knob [13]!
The machine runs on after switching off. Just
■
before the abrasive wheel comes to a standstill,
press the red spindle locking knob [13].
3 The quick-clamping nut [9] is loosened automati-
cally by approx. half a turn and can then be
unscrewed without additional force or tools.
28
Operation
Setting the spindle speed (depending
on configuration)
Set the recommended spindle speed at adjust-
■
ment wheel [2].
— (Small number
large number = high speed)
• Cutting and roughing wheel, grinding brush,
diamond cut-off wheel: high speed
• Brush: medium speed
• Grinding disc: low to medium speed
Information
We recommend the use of our angle
polishers for polishing work.
Switching ON/OFF
WARNING!
Risk of severe injuries.
¾ Always guide the machine with
both hands.
¾ First switch on, then bring the
attachment into contact with the
workpiece.
WARNING!
Danger of unintentional starting
¾ Always switch off the machine
when the mains plug is removed
from the plug socket or if a power
failure has occurred.
DANGER!
Risk of a dust explosion.
¾ Take care to prevent the machine
from drawing in additional dust
and chips.
¾ Keep away from dust deposits
when switching the machine ON
and OFF.
= low speed;