Start The Engine - Pramac Pmi3000 Manual Del Operador

4 Start the engine

 If the engine is started after first time fuel-filling, or long time storage, or after the fuel
was run out, please open the fuel valve for 10 to 20 seconds before starting the engine.
4.1 Open the fuel valve, see figure 6.
Figure 6. Fuel valve knob in the state of open.
4.2 Pull the choke lever.
Do not use choke when the engine is hot or the temperature is high. See figure 7.
Figure 7. Choke activated for cold start
4.3 Turn the engine stop switch (on panel) ON.
See figure 8.
Figure 8 The engine-stop switch position.
4.3 Gently pull the starter handle until feel force, then pull rapidly in
the direction of the arrow shown below.
See figure 9.
9