Warning; Caution; Contents; Quick Start - Mitsubishi Diamond Plus 230 SB Manual Del Usuario

WARNING

TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S
POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR
OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED.
REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH
VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

Contents

User's Manual
Sales
Office List Power Cord

Quick Start

Figure A.1
Power Outlet
Power Cord
Figure C.1
01_English
CD-ROM
Video Signal Cable
(VGA –VGA)
Mac Adapter
(not included)
Figure B.1
Power Button
Power Indicator
Figure D.1
1
RISK OF ELECTRIC SHOCK • DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol warns user that uninsulated voltage within the unit may
have sufficient magnitude to cause electric shock. Therefore, it is
dangerous to make any kind of contact with any part inside this unit.
This symbol alerts the user that important literature concerning the
operation and maintenance of this unit has been included. Therefore,
it should be read carefully in order to avoid any problems.
Your new Diamond Plus 230
following:
• Diamond Plus 230 SB Monitor with tilt/swivel base
• Power cord
• Video Signal Cable (VGA - VGA)
• User's Manual
• Sales Office List
• CD-ROM:
Includes complete User's Manual in PDF format and Windows
related files (INF file and colour profile). To see the complete
User's Manual, Acrobat Reader 4.0 must be installed at your PC.
* Remember to save your original box and packing material to
transport or ship the monitor.
To attach the Diamond Plus 230
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more
information, refer to the display card manual.
3. For the PC: Connect one end of the signal cable to the
connector of the display card in your system (Figure A.1).
Tighten all screws.
For the Mac: Connect the Macintosh cable adapter
(not included) to the computer (Figure B.1).
Attach one end of the signal cable to the Macintosh cable
adapter (Figure B.1).
NOTE: Some Macintosh systems do not require a Macintosh
cable adapter.
4. Connect the other end of signal cable connector on the back of
the monitor.
NOTE: Incorrect cable connections may result in irregular
operation, damage display quality/components of CRT monitor.
5. The Windows ® 95/98/2000/Me/XP INF file for your monitor can
be found on the CD-ROM, delivered with the monitor.
6. Connect one end of the power cord to the AC inlet on the back of
the monitor and the other end to the power outlet (Figure C.1).
7. Turn on the monitor (Figure D.1).
8. Turn on the Computer.
NOTE: If you have any problems, please refer to the
Troubleshooting section of this User's Manual.
English-1
08/05/2002, 15:34

CAUTION

SB
monitor box* should contain the
SB monitor to your system, follow