W Orking Instructions; Reventive Maintenance - SUHNER ABRASIVE LFC 11 Documentación Técnica

3.2 w
orking instructions
3.2.1 s
Awing
Before sawing work the support must be attached
and secured for safety reasons.
To attach the support loosen the screw, push in the sup-
port, and retighten the screw, The support sets the cutting
depth and eliminates vibrations on the workpiece. To ad-
just the position of the support you need only loosen the
screw by half a turn, set the distance you want by hand,
and retighten the screw.
You can use the swivel ring on the stroke adjuster to set
the max stroke. Apply the power tool only with a slight
pressure for sawing. Use suitable lubricants on metal ma-
terials.
3.2.2 f , ,
iling deburring Polishing
Configure the attachment, workpiece, stroke length, and
stroke frequency as described. When deburring draw the
file against the burr. Suitable lubricants can improve the
performance considerably.
3.2.3 A
djusting the stroke frequency
A pressure reducing valve upstream of the power tool can
be used to reduce the stroke frequency by reducing the
pressure.
4.1 P
power tool is used at irregular intervals, its moving parts
and the guide must be treated with a resin-free oil: apply
a number of oil drops inside the hose and let them run into
the power tool.
4.1.1 r
Draw the exhaust air hose and replace this hose with a
new one.
4.1.2 r
,
And lAPPing
To remove the finder guard loosen the screw. Insert the
tool holder to the stop on the piston rod. Tighten the se-
curing screw with 2.5-3Nm.
4. S / m
ERvICE

reventive mAintenAnce

Check the flat guide every day for wearing
and if necessary replace this. Check daily
that the piston travels smoothly. When the
ePlAcement of the exhAust Air hose
ePlAcement of the tool holder
aINTENaNCE
17