Battery Installation - MD SPORTS BG132Y21008 Instrucciones De Ensamblaje

Tabla de contenido

Publicidad

English
ELECTRONIC SCORER OPERATION

BATTERY INSTALLATION

Battery Box: Unscrew the bolt using a screwdriver and
open the battery box. Insert 3x1.5V "AA" batteries ( not
included) in the sequence of polarity as shown on the
inside cover. Then close the cover using a screwdriver.
REMINDING
a.
The batteries must be installed according to their
correct polarization (+ and -).
b.
Please clean the battery contacts and also those of
the device prior to battery installation.
c.
If the game will not be used for a long period of time,
we recommend removing the batteries.
WARNING
1.
Requires 3x1.5V "AA" batteries (not included).
2.
Do not mix old and new batteries.
3.
Do not mix alkaline, standard (carbon-zinc), or
rechargeable (ni-cad, ni-mh, etc.) batteries.
INCOMPLETE NUMBERS ARE DISPLAYED ON
SCORER SCREEN
• Low Battery Warning: When the battery level is very low, a
"BATTERY LOW" voice will ring out 3 times by the scorer.
• Please check the battery charge is sufficient.
• Please replace the battery.
CONTROL BOX OPERATION
Press "ON / OFF" to activate the scorer.
Scoreboard "HOME" shows "01" (pre - set game 1).
Press "SELECT UP and DOWN" to select a game.
Press "PLAY" to enter the selected game mode.
Press "SOUND" to switch the sound ON / OFF while
playing.
Press "PAUSE" to pause or start time counting.
Press and hold the "ON / OFF" button for 3 seconds to
turn off the scorer.
Press and hold the "RESET" button for 3 seconds to
reset the game.
Note: If no shot is made or no button is pressed in 5
mins, the scorer will be turned off automatically.
BG132Y21008
(Continued on the next page.)
OPERACIÓN DEL MARCADOR ELECTRÓNICO
Compartimento de pilas: Desatornille el perno utilizando
un destornillador y abra el compartimento de pilas. Inserte
3 pilas "AA" de 1.5V (no incluidas) como se indica en el
interior del compartimento de las pilas. A continuación,
cierre la cubierta utilizando un destornillador.
ATENCIÓN
a.
Las pilas deben ser instaladas de acuerdo con su
polaridad correcta (+ y -).
b.
Limpie los contactos de las pilas y también los del
dispositivo antes de instalar las pilas.
c.
Si el juego no va a utilizarse durante un periodo
prolongado de tiempo, le recomendamos retirar las
pilas.
ADVERTENCIA
1.
Requiere 3 pilas "AA" de 1,5V (no incluidas)
2.
No mezcles baterias viejas y nuevas.
3.
No mezcle pilas alcalinas, estándar (carbón-zinc), o
recargables (ni-cad, ni-mh, etc.).
LOS NÚMEROS INCOMPLETOS ESTÁN MOSTRADOS
EN LA PANTALLA DEL MARCADOR
• Advertencia de Batería Baja:Cuando el nivel de la batería
está muy bajo, una voz de "BATTERY LOW" sonará 3 veces
por el marcador.
• Por favor, revise la carga de batería si fuere suficiente.
• Por favor cambia la batería.
OPERACIÓN DE CAJA DE CONTROL
Presione "ON / OFF" para activar el marcador.
El Marcador "HOME" indica "01" (juego 1 pre - fijado).
Presione "SELECT UP y DOWN" para seleccionar el juego.
"PLAY" para
Presione
seleccionado.
Presione "SOUND" para cambiar prender o apagar el ON /
OFF cuando está jugando.
Presione "PAUSE" para apagar o iniciar el contado el
tiempo.
Oprima y detenga la perilla "ON / OFF" por 3 segundos
para apagar la tabla de puntaje.
Oprima y detenga la perilla "RESET" por 3 segundos para
resetear el juego.
Nota: Si no se ha realizado tiros o presionado el botón en 5
minutos, el marcador se apagará automáticamente.
19
(Continúe en la siguiente página.)
INSTALACIÓN DE BATERÍA
entrar
al
modo
de
www.medalsports.com
Español
juego

Publicidad

Tabla de contenido
loading

Tabla de contenido