Mounting With Mountings - THERMEx METZ MAXI Instrucciones De Montaje

M 423193161026112015

MOUNTING WITH MOUNTINGS

1
Measure and carve the hole in the ceiling
according to the chosen range hoods
measurements
3
Ceiling
The range hood must be pushed up until the mountings "click" over the construction the
range hood is to be mounted in.
If the mountings does not "click" they can be pushed in place, by pressing on the screws
that holds the mountings. This is done by pushing through the four holes in the corners of
the range hood with a screwdriver.
Note: when mounting in a horizontal division Thermex recommends that the range hood
is insulated to avoid noise nuisance.
THERMEX METZ MAXI, METZ MEDIO & MONSUN II 59
Click!
4x
2
Push the range hood up into the carved hole
in the ceiling. Note: Be aware of the way the
door of the range hood is opened before the
range hood is mounted in the ceiling.
Click!
Range hood
Mounting