Reinstalling Lug Nuts; Changing The Fuse; Accessories; Maintenance And Cleaning - NORAUTO 46866 Manual De Instrucciones

8. Remove wheel.
IMPORTANT INFORMATION FOR USE OF IMPACT WRENCH
To maintain the life of your Impact Wrench, it is recommended that you do not continuously
remove more than ten lug nuts. After ten lug nuts, let the Impact Wrench cool down for
approximately 15 minutes before attempting to remove additional lug nuts. In general, after
10 minutes of operation, let the Impact Wrench cool down for approximately 15 minutes
before attempting to remove additional lug nuts.
1. Slide lug nuts onto the wheel bolts in the order recommended by the lug nut manufacturer.
2. Hand tighten the lug nuts until securely fastened.
3. Do not tighten the lug nuts with the impact wrench. Excessive torque may cause
damage.
4. Use a torque wrench to check that the lug nuts are tightened enough per the manufacturer's
recommendations.
5. Remove jack stands. Carefully lower vehicle and remove the jack. Unplug the impact wrench
and store.
NOTE Always replace fuse with a 15 A-250 V fuse of the same style.
1. Turn and remove the plastic cap and pull out fuse.
2. Insert new fuse inside the case and reinstall the fuse cap.
FUSE CASE
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may create a risk of injury when used on another
tool.
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside the
casing. Never immerse any part of the tool in a liquid. Always keep the ventilation openings
clear.
Always store the impact wrench inside the case in a dry safe location. Keep away from
caustic fluids, water, oil, grease, gasoline or any other substance that may damage the
tool.

REINSTALLING LUG NUTS

CHANGING THE FUSE

ACCESSORIES

MAINTENANCE AND CLEANING

99
FUSE
FUSE CAP