Before You Begin; Tools Needed; Component List - Barrette EPN-51920 Manual Del Usuario

WARNING:
• Improper installation of this product can result in personal injury. Always wear safety goggles when
cutting, drilling and assembling the product.
• Incorrect installation may cause harm to the gate or individual.
• Meets Pool Safety Code*
• DO NOT allow children to play with gate.
NOTICE:
• DO NOT attempt to assemble the kit if parts are missing or damaged.
• DO NOT return the product to the store, for assistance or replacement parts call: 1-800-336-2383.
* Must be used with pool code approved self-closing hinges and installed at required height specified
per local building code. Always refer to all local building codes prior to use.

BEFORE YOU BEGIN:

When installing a gate on a fence, please
note that vinyl gate posts require an internal
support system for weight-bearing purposes
and therefore wooden inserts or a post
stiffener is required. Post stiffener needs to
be purchased separately.
Always consult your local building code
department for applicable regulations and
product acceptance.

Component list:

Item QTY Description
1 1 Latch Assembly
2 2 Mounting Bracket A
3 1 Striker Assembly
4 13 #10 x 1 Square/Phillips Screws
5 1 Square Drive Bit
6 2 Keys
7 1 Mounting Bracket B
The latch assembly is
preset at the factory for
an ideal ¾" gate gap &
installation convenience.
To obtain and review a copy of the warranty please visit: barretteoutdoorliving.com. You may also contact us at
1-800-336 2383 or email Cs.outdoorliving@ebarrette.com
2
2
6
4
The brackets are pre-mounted and ready to
install for a left handed gate.
If you have a right handed gate, follow
instructions to flip the "A" brackets
Left Hand
Configuration

TOOLS NEEDED:

Gate
Safety Glasses
Pencil
Drill
1 ⁄ " Drill Bit - for pre-drill if needed
8
Phillips Drive
Square Drive (Optional)
Tape Measure
1
3
5
A & B down off
2
the latch flip them
to opposite direction
Right Hand
Configuration
HOW TO
FLIP "A"
BRACKETS:
7
Slide brackets
and replace.
Unscrew
1
adjustment
screw