Connecting Speakers; Important - JVC CA-HXZ9 Manual Del Usuario

AM antenna
1
2
3
AM loop antenna
(supplied)
1
If cords are covered with insulation, twist the
core of the cord at the end of each cord, then
remove the insulation.
2
Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
3
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other terminals
and connecting cords.
• Keep the antennas away from metallic parts of the unit, connecting
cords, and the AC power cord.
7

Connecting Speakers

To connect front speakers and subwoofer
Vinyl-covered wire
(not supplied)
Black
1
2
3
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
1
2
Speaker cords
Blue
Black
Red
Speaker
cords
from right
subwoofer
terminal
Subwoofer
Right
main speaker
If cords are covered with insulation, twist the
core of the cord at the end of each cord, then
remove the insulation.
Insert the end of the speaker cord into the
terminal as illustrated.
Match the same polarity: (+) to (+) and (–) to (–).
Close the speaker terminals.
• DO NOT connect more than one speaker to each
speaker terminal.
• DO NOT push or pull the speakers as this will
damage the foot spacers at the bottom of the
speakers.
3
Speaker cords
Blue
Black
Red
Speaker
cords
from left
subwoofer
terminal
Left
main speaker