Air Source - BGS technic 3287 Manual De Instrucciones

AIR SOURCE

Clean and dry air and a correct air pressure is recommended as air supply for this air tool.
Maximum of 90 PSI at the air tool is recommended for most air tools of this class. Check specifications
section for recommended pressure. (Depending on length of air hose and other circumstances, air
pressure at compressor may need to be increased to 100 PSI to ensure 90 PSI at the tool. Water in the air
hose and compressor tank contributes to reduced performance and damage of the air tool. Drain the air
tank and filters before each use and as necessary to keep the air supply dry. Hose length over 25" causes
loss in line pressure. Increase hose ID or increase compressor pressure to compensate the pressure
Use an in-line pressure regulator with gauge if air inlet pressure is critical.
RECOMMENDED AIR SUPPLY
No.
1 Air Tool
2 Air Hose
3 Quick Coupler
Oiler (only required for air tools with
4 motor)
5 Pressure Regulator
SERVICE
•
Only operate the product on compressed air systems that have the correct air pressure and
sufficient air volume (L / min) for this tool.
•
Before using the compressed air device, put 4 to 5 drops of compressed air device oil into the
compressed air connection. The performance of the device depends on the size of the air
compressor and the compressed air supply volume.
•
The speed can be set via an air supply controller (not included in the scope of delivery).
•
The technical data of the tool refer to a working pressure of 6.3 bar.
•
Always be careful when using the Air Grinder. In case of negligent operation, internal
components of the device can be damaged and the work performance can be restricted.
•
Press the actuation lever (trigger) to operate the tool.
•
Release the operating lever to stop the tool.
•
Do not remove any information labels from the device and replace damaged labels.
•
Keep hands, loose clothing and long hair away from the moving part of the tool.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Description
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
No. Description
6 De-Watering / Filter Unit
7 De-Watering Valve
8 Shut-Off Valve
9 Dryer / Filter Unit
Compressor / 11 De-Watering
10
Valve
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
loss.