Machine Information; Technical Specifications - VONROC CT501AC Manual Del Usuario

EN
• Compare the maximum number of revolutions
allowed of the accessories with the number of
revolutions of the machine.
• When you put the machine away the engine must
be switched off and moving parts must have
reached a standstill.
• Never attach an assembly spanner to your ma-
chine with a piece of string or anything similar.
• Never use the axle locking button if the machine
is operating.
• Make sure that the spring chuck diameter is the
same as the axle diameter of the accessory.
• Use a clamping device for securing the work piece.
• Keep your hands away from the work piece.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions.
Always check that the power supply
corre sponds to the voltage on the rating plate.
Class II machine - Double insulation -
You don't need any earthed plug

2. MACHINE INFORMATION

Intended use
This power tool is intended to function as a grinder,
sander, wire brush, polisher, carving or cut-off
tool. This rotary multi tool is great for editing of
materials like wood, plastic, stone, shell aluminium,
brass and steel. Always use the proper accessories
and speed setting.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power consumption
No load speed
Capacity of spring chuck
Weight
Lpa (Sound pressure level)
Lwa (Sound power level)
Vibration
6
CT501AC/S_CT501AC
220-240V~
50 Hz
160 W
8.000-35.000/min
3.2 + 2.4 mm
1.75 kg
73+3 dB(A)
84+3 dB(A)
3.74+1.5 m/s
2
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 3
Fig. A
1. Chuck
2. Spindle lock
3. Chuck spanner
4. On/off switch
5. Speed adjustment wheel
6. Pin
7. Pin opening
8. Ring of machine
9. Inner shaft
10. Ring of flexible shaft
11. Stand
12. Workbench clamp
13. Safety guard
14. Milling attachment
15. Depth knob
3. OPERATION
Before assembly always remove the plug
from the mains.
Warning! Change accessories by inserting an
accessory into the collet (or chuck) as far
possible to minimize run out and unbalance.
Assembly of accessories (Fig. A)
Press down the spindle lock (2) and hold it down.
Using the chuck spanner (3) you can undo the
WWW.VONROC.COM