Problems - melitta CAFFEO BARISTA T Manual Del Usuario

10

Problems

If the actions listed below fail to rectify the problems or other problems not
listed here occur, contact our hotline.
Email to: melitta.consumer.service@mh.melitta.de
Problem
Coffee only emerges
from the outlet in
drips.
Coffee does not flow. Water tank not filled
Fill beans appears on
the display although
the bean container
is filled.
Loud grinder noise.
Brewing unit cannot
be inserted after
removing.
System error appears
on the display.
Cause Action
Grinding fineness
ƒ
too fine.
Appliance soiled.
ƒ
ƒ
Appliance calcified.
ƒ
ƒ
or inserted incor-
rectly.
Brewing unit
ƒ
clogged.
Beans do not drop
ƒ
into the grinder.
ƒ
ƒ
"BEAN SELECT"
ƒ
slider is in the centre
position.
Foreign object in the
ƒ
grinder.
Brewing unit is not
ƒ
locked correctly.
Drive is not in the
ƒ
correct position.
Software problem
ƒ
ƒ
Set a coarser grinding fineness (see
chapter 8.7 on page 35).
Clean the brewing unit (see chap-
ter 9.3 on page 38).
Run the cleaning programme (see
chapter 9.6 on page 40).
Descale the appliance (see chap-
ter 9.7 on page 41).
Fill the water tank and ensure it is
positioned correctly (see chap-
ter 4.6 on page 19).
Clean the brewing unit (see chap-
ter 9.3 on page 38).
Tap lightly on the bean container.
Clean the bean container.
Coffee beans too oily. Use different
coffee beans.
Move the "BEAN SELECT" slider to
the right or left.
Contact the hotline.
Check whether the handle for the
brewing unit locking mechanism is
correctly engaged (see chapter 9.3
on page 38).
Press and hold the "My Coffee" but-
ton. Also press the ON/OFF button.
The appliance initialises. Release
the buttons again.
Switch the appliance off and
on again (see chapter 4.1 on
page 13).
Contact the hotline.
Problems
45