Technical Data; Core Bit Diameter - Hilti DD 150-U Manual De Instrucciones

4

Technical data

4.1 Diamond core drilling machine
For rated voltage, rated current, frequency and/or input power, refer to the country-specific rating plate.
If the product is powered by a generator or transformer, the generator or transformer's power output must
be at least twice the rated input power shown on the rating plate of the product. The operating voltage of
the transformer or generator must always be within +5 % and -15 % of the rated voltage of the device.
Weight according to EPTA Procedure-01
Weight of the drill stand with combination base plate and carriage
Permissible water supply pressure
Ideal distance of the mark on the anchor base plate from the hole center
Ideal distance of the mark on the vacuum base plate from the hole center
Ideal distance of the mark on the combination base plate from the hole
center
Drilling depth
4.2 Bluetooth
Frequency range
Maximum output power
4.3 Working with vacuum base plate
Minimum vacuum
Max. core drilling tool diameter
4.4

Core bit diameter

Ø core bits (stand-
guided drilling, wet)
Ø core bits
(hand-guided)
Ø core bits
(hand-guided dry core
bits with PCD)
4.5 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
*2204400*
1st gear
102 mm ... 162 mm
121 mm ... 162 mm
52 mm ... 162 mm
2204400
2nd gear
28 mm ... 87 mm
41 mm ... 112 mm
•/•
DD 150-U
8.4 kg
13.3 kg
≤ 6 bar
267 mm
292 mm
292 mm
450 mm
2,400 MHz ...
2,483 MHz
10 dBm
0.65 bar
162 mm
3rd gear
12 mm ... 25 mm
8 mm ... 37 mm
•/•
English 43