Safety Rules - Upright XRT27E Electric Manual Del Operador

English Language Section English Language Section English Language Section English Language Section
Electrocution Hazard Electrocution Hazard Electrocution Hazard Electrocution Hazard
THIS MACHINE IS THIS MACHINE IS THIS MACHINE IS THIS MACHINE IS
NOT INSULATED. NOT INSULATED. NOT INSULATED. NOT INSULATED.
USE OF THE AERIAL WORK PLATFORM: This aerial work platform is intended to lift persons and their tools as well as the mate-
rial used for the job. It is designed for repair and assembly jobs and assignments at overhead workplaces (ceilings, cranes, roof
structures, buildings, etc.). All other uses of the aerial work platform are prohibited!
THIS AERIAL WORK PLATFORM IS NOT INSULATED! For this reason it is imperative to keep a safe distance from live parts of
electrical equipment!
Exceeding the specified permissible maximum load on the platform is prohibited!
XRT27E
XRT33E
The use and operation of the aerial work platform as a lifting tool or a crane (lifting of loads from below upwards or from up high on
down) is prohibited!
NEVER exceed 400 N (90 lbs.) of side force.
DISTRIBUTE all platform loads evenly on the platform.
NEVER operate the machine without first surveying the work area for surface hazards such as holes, drop-offs, bumps, curbs, or
debris; and avoiding them.
operate the machine only on surfaces capable of supporting wheel loads.
NEVER operate the machine when wind speeds exceed 45 km/h (28 mph) (12,5 m/sec.= Beaufort scale 6).
IN CASE OF EMERGENCY push EMERGENCY STOP button to deactivate all powered functions.
Climbing up the railing of the platform, standing on or stepping from the platform onto buildings, steel or prefab concrete structures,
etc., is prohibited!
Dismantling the swing gate or other railing components is prohibited! Always make certain that the swing gate is closed and
securely locked!
It is prohibited to keep the swing gate in an open position (held open with tie-straps) when the platform is raised!
To extend the height or the range by placing of ladders, scaffolds or similar devices on the platform is prohibited!
NEVER perform service on the machine while the platform is elevated without supporting the elevating assembly.
INSPECT the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks, loose wire connections, and dam-
aged cables or hoses before using.
VERIFY that all labels are in place and legible before using.
NEVER use a machine that is damaged, not functioning properly, or has damaged or missing labels.
IF ALARM SOUNDS while the platform is elevated, STOP , carefully lower the platform. Move the machine to a firm, level surface.
To bypass any safety equipment is prohibited and presents a danger for the persons on the aerial work platform and in its working
range.
NEVER charge batteries near sparks or open flame. Charging batteries emit explosive hydrogen gas.
Modifications to the aerial work platform are prohibited or permissible only at the approval of UpRight.
AFTER USE, secure the work platform from unauthorized use by turning both keyswitches off and removing the key.

Safety Rules

Tip Over Hazard Tip Over Hazard Tip Over Hazard Tip Over Hazard
NEVER elevate the platform
or drive the machine with the
platform elevated unless on
firm, level surface.
567 kg (1250 lbs.) including four (4) persons
454 kg (1000 lbs.) including three (3) persons
Collision Hazard Collision Hazard Collision Hazard Collision Hazard
NEVER position the platform
without first checking for
overhead obstructions or
other hazards.
Fall Hazard Fall Hazard Fall Hazard Fall Hazard
NEVER climb, stand or
sit on the platform
guardrails or midrail.