Installation Instructions - CHIEF iC Serie Manual De Instrucciones

Installation Instructions

1
(F)
2a
Center of screen
3
(A)
Vertical center
of mount
INSTALLATION
The iCMPFM2 and iCMPTM2 have been designed to be
mounted directly onto either a wood stud or concrete wall. The
iCMPFM2 has static brackets which keep the TV in an upright
position. The iCMPTM2 has brackets which allow the TV to be
tilted.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT! It is the installers
responsibility to make certain the structure to which the
mount is being attached is capable of supporting five times
the weight of the iCMPFM2 or iCMPTM2 and all attached
equipment not to exceed 125 lbs (56.7 kg).
Assembling the Wall Mount
1. Place both wall uprights (F) on the floor.
2. Slide rails (A) into wall uprights.
3. Thread endcaps (G) into the end of each rail.
(G)
NOTE:
Proceed to either the Installing to a Wood Stud Wall
(2a) section or the Installing to a Concrete Wall (2b)
section.
Installing to a Wood Stud Wall
4. Determine the center of the TV screen, and where it should
be located on the wall.
5. Locate the closest stud to the left and right of the selected
location.
NOTE:
If the screen area lies over a stud, use that stud and
the stud to either the left or right of it.
6. Line up the diamond on mount with center of screen
6"
marking to determine vertical center.
7. Measure up 6" from the center point to mark location of the
upper mounting slots.
iCMPFM2 / iCMPTM2
11