CHIEF iC Serie Manual De Instrucciones página 12

iCXPFM2 / iCXPTM2
2a
3
(J3) x 4
6
4 5
12
1.
1 2
2.
3.
4.
(J2) x 4
5.
6.
7.
Using a level, mark the wall on each stud to attach the
mount through the upper mounting slots.
WARNING:
ELECTRICAL SHOCK HAZARD! CUTTING
OR DRILLING INTO ELECTRICAL CORDS OR CABLES
CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY!
ALWAYS make certain area behind mounting surface is free
of electrical wires and cables before drilling or installing
fasteners.
WARNING:
EXPLOSION AND FIRE HAZARD! CUTTING
OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH
OR SERIOUS PERSONAL INJURY! ALWAYS make certain
area behind mounting surface is free of gas, water, waste, or
any other plumbing before cutting, drilling, or installing
fasteners.
CAUTION:
MINIMUM HORIZONTAL DISTANCE
BETWEEN WALL BRACKETS IS 24". Do not place
mounting brackets closer together than 24".
Drill one 7/32" (5.5mm) pilot hole in each stud.
Use two 5/16 x 2-1/2" lag bolts (J3) and two 5/16" flat
washers (J2) to attach top of mount to wall.
Mark the attachment points for the lower mounting slots,
making sure the attachment points are located on the
studs.
Drill 7/32" (5.5mm) pilot holes at markings for lower
mounting holes.
Use two 5/16 x 2-1/2" lag bolts (J3) and two 5/16" flat
washers (J2) to attach the mount to the wall through the
lower mounting holes.
Slide rails to approximate center of screen location.
Installation Instructions