CHIEF iC Serie Manual De Instrucciones página 16

iCXPFM2 / iCXPTM2
5
NEVER place both interface brackets to one
side of the wall mount center line (CL)!
Both interface brackets must NEVER be located
to one side of the wall brackets!
5a
Pull strap
16
Center Line (CL)
Top
1
Hook
4
Attaching Screen to Wall Mount
1. (iCXPTM2 only) Adjust Velcro® pull strap (if necessary) so
it does not extend beyond bottom of screen.
NOTE:
Do NOT allow both interface brackets to be located on
same side of wall bracket.
NOTE:
NEVER place both interface brackets to one side of the
wall mount center line!
NOTE:
Proceed to either Step 5a Attaching to iCXPTM2, or
Step 5b Attaching to iCXPFM2.
Attaching to iCXPTM2
1. Hang top hook of interface brackets onto the top bar of the
mount.
NOTE:
The screen initially installs into the "kickstand mode" to
allow easy cable access.
2. Slide screen and bars to desired viewing position.
3. Route cables between wall and bars.
CAUTION:
PINCH POINTS! Keep fingers, hands and
cables out of pinch point areas.
4. Pull downward on the pullstraps and swing inward toward
wall, latching interface brackets to lower bar and locking
bottom of screen to the mount.
Installation Instructions