Philips HR 4347/00 Manual De Instrucciones página 5

Placing the air cleaner
• As a rule, the air cleaner
should be given a central
position and should either
be placed on the floor with
its back against the wall or
hung on the wall (fig. 2-4).
• Excess cord can be stored
at the back (I) of the
appliance (fig. 1).
3
• Never cover the air inlets or
outlet (fig. 5).
• When you are using a
heating device: position the
air cleaner in such a way
that the airflow caused by
the appliance coincides with
the convective airflow of the
heating device. You should
therefore place the air
cleaner next to the radiator
or other heating appliance
(fig. 6-7).
6
• It is possible to use more than one air cleaner in a room.
This is advisable if the room is very big and/or has an
irregular shape. In this case it is best to put both appliances
against the same wall, yet as far removed from each other
as possible.
• For proper cleaning of the air in a room, we advise you to
use one HR 4347 air cleaner in rooms with a surface area of
2
up to approx. 40 m (100 m
• Particularly people who suffer from a respiratory allergy are
advised to put an air cleaner in the living room as well as in
the bedroom and to let both air cleaners run continuously.
2
4
5
7
3
).
Preparing the air cleaner for use
• Before you use the appliance for the first time: fill the
active carbon filters with the supplied carbon granules (see
'Replacing the active carbon'). The white sticker that comes
with the granules is not used in combination with this type of
air cleaner; you can throw it away.
The replacement indicator does not yet have to be reset.
- Put the plug in the wall socket.
The pilot light above the on/off control (J), the digits on the
display (00:00) and the clock symbol a start blinking (this
will also happen after a power cut).
The display is unlit.
- Press the on/off control
(fig. 8).
The display lights up and the
appliance starts running at
speed 1.
The pilot light above the
on/off control burns
continuously to indicate that
the appliance is switched on.
Setting the air cleaner manually
- Switch the air cleaner on
(fig. 9).
The pilot light above the
on/off control comes on and
the display lights up.
The appliance starts running
at speed 1.
10
- Select speed 1, 2 or turbo by pressing the speed control (L)
(fig. 10).
The pilot lights indicate the speed selected.
• For quick air cleaning, select the turbo setting (fig. 11) and
switch to speed 2 after approximately 30 minutes.
• For a continuous supply of fresh, clean air in your room, run
the appliance continuously at speed 1 or 2.
'Auto' position
When set to the 'Auto' position, the air cleaner automatically
selects the speed which effectively removes most gases from
the air. It is best to set the air cleaner to the 'Auto' setting
before air pollution occurs. The gas sensor (R) in the appliance
registers the gas concentration in the room in which the
appliance is running.
5
8
9
11