Short Cord Instructions - Kalorik USK JK 28345 Manual De Instrucciones

Fax +32 2 359 95 50
16. When removing lime scale, only use special products for the
removal of lime scale. Never use ammonia or any other
substance that might damage your health.
17. Ensure that the kettle is properly located on the power base
before switching on.
18. Remove the kettle from power base before filling or pouring. Do
not attempt to remove the kettle from the power base until it is
switched off, manually or automatically.
19. Use the kettle only with the power base supplied and vice versa.
20. Use on a hard, flat level surface only.
21. Extreme caution must be used when handling or moving kettle
and pouring from the kettle containing boiling water.
22. When pouring a large quantity of hot water, pour slowly and do
not incline the kettle past the horizontal line to avoid burns and
injuries
23. THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY.
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS (3-PRONG PLUG)
This appliance must be grounded. In the event of an electrical short
circuit, grounding reduces the risk of electric shock by providing an
escape wire for the electric current. This appliance is equipped with
a cord having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed and
grounded.
Do not attempt to modify the plug in any way.

SHORT CORD INSTRUCTIONS

A short power supply cord is provided to reduce the hazards resulting
from becoming entangled in, or tripping over a longer cord.
Extension cords are available and may be used if care is exercised in
their use. If an extension cord is used:
The electrical rating of the extension cord should be at least
•
that of the appliance. If the electrical rating of the extension
cord is too low, it could overheat and burn.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
3
Assembly page 3/28
special instruction from Team
USK JK 28345 - 091125