HEIDENHAIN MSE 1201 Instrucciones De Instalación página 23

Installing cable mounting hardware
A cable mounting hardware kit is provided with each module for routing cables. Each kit
contains two sets of mounting hardware.
Insert the M3 hex nut into the cable mounting slot 20 on the bottom of the module
X X
Insert the M3 screw through the cable tie holder and fasten to the M3 hex nut using a
X X
cross-head screwdriver
Insert the cable tie through the cable tie holder and fasten cables with cable tie
X X
Releasing a module
Verify all power switches are in the off position (if applicable) and power is removed
X X
from all power supply modules in the module chain
Press a flat-edge screwdriver into the lock tab receiver 12 opening at the top left of
X X
the right hand module and press down on the lock tab 7 of the left hand module to
release the module
Gently apply upward pressure, depressing the DIN rail spring 15
X X
While keeping upward pressure, rotate the top of the module away from the DIN rail
X X
Gently release the upward pressure, releasing the module from the DIN rail
X X
Releasing a module
23