Steamery Cirrus No.1 Manual De Instrucciones página 5

Cirrus No.1 Steamer
Box Content
1. Cirrus No.1 Travel Steamer
2. Water Container
3. Fabric Brush
4. Measuring Cup
Operating Instructions
THIS STEAMER IS FOR HOUSEHOLD USE ONLY (for commercial use, Steamery recommends
our commercial steamer model Stratus No.2 Professional Steamer.)
Preparations
Remove the water container by pulling it in the opposite direction from the nozzle and lift it
out from the steamer. Carefully loosen (do not remove) the rubber plug on top of the water
container and fill the container with water. Close the water container with the rubber plug
and put it back in position in the steamer. Please note that the water quality is extremely
important for the long-term performance of your steamer. For more info about water quality,
see the paragraph Water and Water quality below.
Water and Water Quality
Water quality is a true science of its own. The most important aspect for a steamer is that the
water is as clean and pure as possible; all in order to minimize the risk of getting residues left
in the steamer's heating device.
We strongly recommend:
First and last and always, use bottled or filtered water, i.e. water meant for drinking (this
•
will radically prolong the lifetime of your steamer)
• Steamery's Steam Water
• Distilled water
• Deionized water, such as battery water
We recommend (with some words of advice):
• The steamer runs well on regular tap water if you live in an area with soft water.
(Hard water contains a higher amount of limestone and minerals which eventually may
compromise the quality of your steamer.
• Unscented Ironing water
We DO NOT recommend:
• Don't use scented and perfumed steaming water, it will clog the steamer and eventually
make it stop working properly
• Never use other fluids than water
Using Your Cirrus No.1 Steamer
1. Turn on the steamer by putting the plug into a power outlet and wait 25-30 seconds until
the red light turns off. This indicates that the steam has reached the right temperature for
use.
2. While steaming, if the red light goes on, wait a few seconds without pressing the button.
The steam needs to reach the right temperature again.
3
1
3
4
2