Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Attach Section to Stair:
a. Position your assembled panel on steps to
location as desired (Fig. 5).
b. Connect your post to the stairs. There are two
options to do this:
Option 1 (Concrete or Wood):
Using the four provided holes in the base plates:
• Mark holes through the mounting plates of
posts (upper and lower) onto the mounting
surface (Fig. 6) and follow masonry anchor
manufacturer's installation instructions for
proper drilling technique.
NOTE:
For Concrete, use four (4)
plated masonry screws (sold separately).
For Wood, use four (4)
ead lag screws (sold separately).
Option 2 (Concrete Only):
Using the
• Determine center of each post. Do this by
marking holes through the mounting plates
of posts (upper and lower) onto the mounting
surface (Fig. 6).
• Remove the rail section and posts. Then, from
the those marks just made, draw an "X" and
where the lines cross is the center (Fig. 7).
• Drill a hole at the center marks with a ½" drill bit
3
⁄
" deep.
3
4
• Clean out hole and fill about
anchoring adhesive.
• Use a
(sold separately), thread it into the hole on the
bottom of the post plates until about 3
extended out under the post (Fig. 8).
• Place rail section into place, being sure that the
rods fit completely into previously drilled out
holes (Fig. 9).
4
1
⁄
" x 5" external hex
3
8
⁄
" threaded hole under the base plates:
1
2
⁄
" x 13 TPI x 12" zinc threaded rod
1
2
⁄
" x 3
⁄
" zinc
1
4
4
⁄
of hole with
1
2
⁄
" remain
1
2
Post
Plate
zinc
Threaded
rod
Fig. 5
Fig. 6
Fig. 7
Center
Fig. 8
Fig. 9
Publicidad
