Publicidad
Idiomas disponibles
Idiomas disponibles
KEB-611
Hydraulic Crimping Tool
Figure 8. Release the pressure
Finish adding oil, please reassemble the parts in sequence.
2. Q：The die cannot be positioned while pressing.
A：The causes are:
<1> Shortage of Oil
<2> Air inside
<3> Impurities inside the reservoir
<4> Impurities inside the tool
them. Then reassemble them.
Figure 9.
Dismantle
the fixed
handle
Figure 10.Pull the plug
Please add oil in the reservoir up to full.
Please add oil in the reservoir up to full.
Take apart the inner parts and clean
6
Exchange new Hydraulic oil.
www.grupotemper.com
Figure 11. Add oil
Publicidad
