TOYAMA TM6AFS Manual Del Usuario página 20

NOTE:
If the outboard is equipped with a stop by a rope, it can also be switched off by pulling it
out and removing the catch present.
Securely tighten the fuel tank breather valve and close the fuel.
Close and disconnect the fuel COCK.
ADJUSTING THE ENGINE POSITION
The motor has four or five holes present for adjusting the motor angle.
1. Turn off the engine.
2. Remove the position adjusting screw while tilting the engine slightly.
3. Replace the screw in the desired position (perform tests in different
positions to find the position that best fits the intended conditions of use).
ATTENTION:
Make sure that the engine is turned off and completely stopped.
Operate your handling carefully.
Be careful not to crimp body parts when removing and replacing the set screw.
Be careful when changing position. Gradually increase the speed after the change to verify that
the boat is stable. Inadequate angles can lead to loss of boat control.
NOTE:
Position the outboard at an angle that ensures balance and stability during navigation. An
excessively large angle of balance is incorrect as it causes the bow to raise (1). On the other
hand, an excessively small angle of equilibrium causes the bow to be submerged (2). It is worth
noting that the most appropriate balance angle depends on the combination of the outboard, boat,
propeller and operating condition.
20